Personal Injury Lawyers

Best Lawyers is published by Best Lawyers in partnership with US News and World Report.  Best Law Firms is published by Best Lawyers in partnership with US News and World Report.  Chambers is published by Chambers and Partners. A description of their selection process can be found in the respective links above. The aforementioned organizations are private peer review organizations, not court specific public certification vehicles.  No aspect of this advertisement has been submitted to or approved by the Supreme Court of New Jersey.

Sources of Asbestos Exposure

There are approximately 3,000 different types of commercial products that contain asbestos. Mined from the ground, then processed and refined into fluffy fibers, it is then added to various types of binding agents.

Asbestos products have been widely used because they are heat and chemical resistant and perform well as an insulating solution. Asbestos also does not corrode. There are few materials that have the characteristics of asbestos, which made it a popular choice for builders and manufacturers throughout most of the 20th century, some of whom have been represented by our asbestos lawyers in NJ.

Asbestos is commonly found in roofing materials, plasters, siding materials, attic insulations, floor tiles, some forms of linoleum, HVAC duct insulation and more.

Below is a list assembled by our asbestos lawyers in NJ that are major sources of asbestos exposure are:

  • Asbestos pipe covering - Generally white and gray in color, this product was placed around pipes. It came in half-moon sections.
  • Asbestos block - Asbestos block was used for insulation around equipment like boilers and tanks. It had a similar appearance to asbestos pipe covering, except it was in a rectangular shape.
  • Asbestos cement - Asbestos cement had to be mixed with water before being applied. Before being mixed, it had a dry, powdery, white-grayish appearance and was used to fill in gaps when using pipe covering and block on equipment like boilers and tanks.
  • Asbestos packing – Identified by a braided rope form, this product varied in appearance from grayish-white to graphite black. Packing was utilized to fill gaps in pump connections and other equipment where high heat could be generated. The packing was needed to seal flanges or joints. Depending on its use, asbestos packing could have either an oily or drier consistency.
  • Asbestos gaskets – Asbestos gasket material was used as a sealant in high temperature lines between flanges and other connections. These products ranged in color from whitish to black, similarly to asbestos packing. It was either sold in sheets or it came pre-cut in the form of circles.
  • Asbestos fire brick - Utilized around furnaces and boilers, asbestos fire brick came in a range of colors from white to gray and was generally cemented in with asbestos furnace cement.
  • Asbestos furnace cement - Available as either a dry or pre-mixed wet material, asbestos furnace cement was typically used to hold bricks together around furnaces or boilers.
  • Asbestos flexible duct connectors - This product was used by sheet metal workers generally in making connections for ducts, which would be carrying high temperature air. 
  • Asbestos tape - Asbestos tape came in a variety of colors ranging from white to black. When this product came in black, it was fibrous in appearance. Asbestos tape was typically used by electricians when sealing or making electrical connections.
  • Asbestos blankets - This product was generally whitish to grayish and used to cover hot equipment while people were working nearby and on turbines or other equipment permanently as an insulating barrier. Asbestos blankets looked very similar to household blankets. 
  • Asbestos wire – With a fibrous appearance, this product came in various forms, but generally had some of the following designations: AF, A, AA, AIA. 
  • Asbestos cable – Asbestos cable had some of the following designations: AVA, AVB or AVL. The outer covering or some of the inner layers would have a fibrous appearance.
  • Asbestos containing heater cord - This product was the type of asbestos wire generally used on toasters and in high voltage electrical overhead lighting. The wire generally had two conductors and had a fibrous outer covering.
  • Asbestos brake linings - Asbestos brake linings were used in all vehicles from the time they were first invented until the mid to late 1970s. It was a grayish, bulky material that was attached to the brake shoe. At this time, asbestos was utilized in both disc and drum brakes.
  • Asbestos clutches – Similarly to asbestos brake lining, asbestos clutches were used in all vehicles from the time they were invented until the 1970s. They were whitish to grayish in color and appeared in the clutch itself.
  • Asbestos corrugated sheets - Asbestos corrugated sheets were utilized in various buildings as a facing or a siding. They had a wave-like appearance and like most asbestos products, were whitish to grayish in color.
  • Asbestos gloves - Asbestos gloves had a fibrous appearance and were used as protection from high temperature situations. They came as either a five-finger glove or a mitten.
  • • Asbestos leggings, aprons or other clothes - All asbestos clothing was worn by workers to protect themselves from high temperature operations. 
  • Asbestos ceiling tiles - While asbestos was commonly used in ceiling tiles, it was not used in all of them. In fact, it is difficult to distinguish which tiles did contain asbestos and which did not.
  • Asbestos floor tiles - Similar to asbestos ceiling tiles, not all floor tiles contained asbestos, making it difficult to distinguish which ones did and which did not.
  • Asbestos fire-proof spray insulation - This product was applied to various areas within a building for fire-proofing. Once sprayed and dried, it had a fibrous appearance.
  • Asbestos wall board - This product was an asbestos containing wall board that was used for various framing and sheeting operations. 
  • Asbestos joint compound - Asbestos joint compound came either as a whitish powder that had to be mixed with water or as a pre-mixed material. It had a plaster-like appearance and was used as a sealing compound for joints with asbestos wall board.
  • Asbestos roofing shingles - This product was very similar in appearance to regular asphalt shingles and was utilized in areas that needed fire-proofing properties. Similar to asbestos floor and ceiling tiles, it was difficult to tell whether or not roofing shingles contained asbestos or not.
  • Asbestos roofing paper or felt - This product was a tar-like material that contained asbestos and was utilized as a base before asbestos shingles were applied. 
  • Asbestos Transite pipe - Whitish to grayish in color, asbestos Transite pipe was a cement pipe material used in numerous underground conduit situations.

The above are some of the more general types of asbestos-containing products. If you feel you are eligible to file a claim, please be sure to advise our asbestos lawyers of everything you did over the course of your career to determine whether there were any other materials you may have worked with that contained asbestos.

If you have been suffering with lung cancer, mesothelioma or pulmonary disease and you have worked with asbestos-containing products in the past, you could be eligible to file a claim.

Contact our asbestos lawyers today for more information or give us a call at 855-800-0093. You can also get a free consultation.

Find more information about asbestos and its uses.